Over that you have to place two orders or call me. So a 20 x40 pool cover would be 903 sq feet and that number would replace the 1 in QTY box. Then add 3 foot to length and 1 to width and multiply by each then place in QTY box. Track width at widest point - inside to inside 'exact' You can always email us or call 1-26 or go to to see a pool in all the colors. We need quite a bit of info to order a replacement cover. Navy Blue, Royal Blue, Light Blue, Beige or Tan, Brown, Forest Green, Light Gray, Charcoal. We are not liable for customers wrong measurements. Color matched webbing is sewn and welded. Ripping and tearing are some of the most common cover problems.All of our covers are made by a leading cover manufacturer. It could just be old and there may not be enough slack to operate it anymore due to shrinkage. Excess water on the cover, dirt in the tracks and pulleys, or the cover being forced in some way will make a pin snap.

But a broken pin also is a sign that something else could be problematic. Sometimes the pin breaks just from normal wear and tear. It’s important to find out what caused the shear pin to break, or it’s likely to happen again and again. A shear pin is designed to break if the gearing system, which engages the rope reels, has too much pressure as it works back and forth. Both are used to prevent a cover from putting pressure on the system if it malfunctions. If it has been dried and still doesn’t work, it probably needs to be replaced.Īnother possibility for a stubborn automatic, cover may be a broken shear pin or, for newer covers, a slipped clutch. Experts recommend letting the motor dry out before attempting to work it again. But even that extra precaution can’t save every motor from water damage. More recently, manufacturers have been making submersible motors that won’t break down if they get wet. Flooding occurs when the failure to clean off the cover before opening it, dumping all the debris in the pit and clogging the drains. It may be seized up from water damage, which is typically caused by drain-pit flooding. If you can’t turn it by hand, electricity won’t be able to turn it either.

One test that you can attempt is to try to turn the motor shaft by hand. However, if power is getting through and the motor still doesn’t operate, it’s time to replace the motor. If not, the problem may be with the power lines, and the electric company may need to be notified. If the key switch doesn’t turn on, then it’s time to check the amperage with a multimeter to see if power is getting to the motor in the first place. Next, follow the line up to see if there is a bad wire. The first thing to do is disconnect the key switch and then touch its wires together to jump-start it, experts say. If the breakers or reset button don’t start the motor, you look over the motor’s internal connections. Many times, it’s simply a matter of pushing a button. Some of the motors have reset buttons on them that need to be checked as well. A common culprit could be a tripped GFCI or breaker. Often these issues can be settled by simply check breaker box or motor compartment. When this happens, cover experts say the first thing to check is the motor and all its connections. The most common problem with automatic covers is that they won’t open or close. Here are some repair tips from experts to help you keep your automatic cover in peak operating condition. Because covers keep dirt and debris out of the pool and allow chlorine residuals to last keep these service allies in tip-top condition. Significant growth in the automatic pool cover Market across the nation.

Automatic pool cover replacement switch